A.3.3 Messages Output by the Parameter Setup Command

This section describes the messages that are output by the parameter setup command.

The environment-dependent constraints in the installation parameters are not checked by this command. Therefore, even if an error is not output by this command, an error may still occur during installation.

System error.

Cause

A system error occurred.

Action

Contact Fujitsu technical support.

Argument error: Usage: dtksd_instparam -infile "input file path" -outfile "output file path".

Cause

The syntax of a required argument is incorrect.

Action

Check the syntax of the command.

Error: too long path specified(path must be less than 256 bytes).

Cause

The specified file path is too long.

Action

Specify the file path using up to 255 halfwidth characters.

Error: file not exist.

Cause

The specified file does not exist.

Action

Ensure that the specified file path is correct.

Error: failed to open file.

Cause

The file could not be opened.

Action

Ensure that the file is not in use, or is not corrupted.

Error: failed to parse csv file.

Cause

Failed to process the CSV file.

Action

Ensure that the CSV file format is correct.

Error: can't find out parameter from input file.

Cause

The file specified in -infile does not contain any parameters.

Action

Check the contents of the file specified in -infile.

Error. DtkSdInstPath is invalid.

Cause

The specified content of DtkSdDBInstPath in the input file is invalid.

Action

Check the content specified in the parameters.

Success: complete to edit Installation file.

Description

Successfully edited the installation parameter file.