11.2.9 Resource Icons

This section describes the icons used to represent resource statuses on NetworkViewer.

The following table details the resource statuses associated with each icon.

Table 11.3 Resource Icons
Icon	Meaning
	Chassis
	Server
	LAN switch blade
	LAN switch blade in IBP mode
	LAN switch blade in VCS mode
	LAN switch blade in Converged Fabric mode
	VM host
	VM guest
	Virtual switch
	L2 switch
	Management host (IPCOM VX)
	SLB (Server Load Balancer)
	Firewall
	Integrated network device
	Ethernet Fabric device
	L-Platform
	L-Server
	Network resource connected to L-Servers
	Firewall resource
	SLB resource

Table 11.4 Resource Status Icons
Icon	Status	Meaning
	normal	No new errors, warnings, or stops were detected.
	warning	A warning was detected.
	unknown	The status could not be obtained.
	error	An error was detected.
	fatal	A fatal error was detected, the resource is now unusable.
	stop	The resource was detected to have been powered off.
	affected	Operation is affected due to trouble involving other resources. All routes to and from particular resources are blocked and some services may be unavailable. This icon is only displayed in Analysis Mode.
	affected	Operation is affected due to trouble involving other resources. The routes to and from particular resources are partially blocked but services are still available. This icon is only displayed in Analysis Mode.

Point

For the logical resources related to multiple physical resources (network, firewall, and SLB resources), the highest priority status of the corresponding physical resources is displayed.
Priority levels of status are as shown below:
```
(High Priority) fatal > error > unknown > warning > stop > normal (Low Priority)
```

For virtual switches, the status of the VM host to which they belong is displayed.

Table 11.5 Physical-Logical Relationship Icon
Icon	Meaning
	Visualization target of physical resources and logical resources

Table 11.6 Search Target Icon
Icon	Meaning
	Represents the target for searches of resources.

Table 11.7 Point-to-Point Route Search Icon
Icon	Meaning
	Represents the resource as the starting point of a route search.
	Represents the resource as the end point of a route search.

Table 11.8 Port Icons
Icon	Meaning
	Connected port
	Not connected port

Table 11.9 Port Status Icons
Icon	Status	Meaning
	normal	No ports with "error" or "disabled" status were detected. The state of the port is always displayed as normal status for LAN switch blades that operate in Converged Fabric mode or LAN switch blade PY CB 10Gb FEX Nexus B22.
	error	An error was detected from the port (e.g. the opposite port of the NIC, L2 switch, or Ethernet Fabric was disabled, or the cable between this link and its opposite port or NIC was disconnected). When ports of a network device other than a LAN switch blade are disabled, the state of the port is displayed as error.
	disabled	The port was detected to have been disabled (offline).

Point

For the ports of the following resources, the status of the resource to which they belong is displayed.

The following tables detail the icons displayed in the NetworkViewer.

Table 11.10 Admin Server Icon
Icon	Status	Meaning
	Admin server	Indicates the server used as the admin server.