It is necessary to define that the server can be used as a VM software agent without using an agent for Resource Orchestrator, by creating the definition files before registering a server. When registering the server, select the [Register agent] checkbox, and register the server as VM host. In VM hosts registered using these definitions, obtain the server status or hardware configuration information (CPU core count, CPU clock speed, memory capacity, etc.) from VM software.
When the definition file is changed after registration, the modification is not valid.
Note
The server cannot be used for anything other than a VM host (spare server or Windows/Linux server).
Even if the following settings are configured, priority is given to the information obtained from VM software.
Configuration when Creating a Virtual L-Server Using a Server which cannot Use ServerView Agents
Configurations to specify "Enable" for server management software (ServerView) when creating a server
On VM hosts registered using this definition, the following functions cannot be used.
Server switchover
In the system configuration file for pre-configuration, do not describe the values in the following section header parameter for section name [Server]: If the values are described, registration fails.
snmp_community_name
[Windows Manager]
Installation_folder\SVROR\Manager\etc\customize_data
[Linux Manager]
/etc/opt/FJSVrcvmr/customize_data
Point
In the storage location above, the sample definition file (server_control.sample.rcxprop) is stored. When using the sample as the definition file, place the file after deleting the ".sample" included in the file name.
server_control.rcxprop
[Windows Manager] [Linux Manager]
UTF-8
[Windows Manager]
CR/LF
[Linux Manager]
LF
The following line must be entered in the first line of definition files.
ServerControl,V1.0 |
In the definition file, the name of each server is described on an individual line.
When defining two or more servers, use line breaks.
Each line is entered in the following format.
physical_server |
Even if there are multiple same physical server names in the individual lines, no errors occur.
When adding comments, start the line with a number sign ("#").
Enter the same physical server name as the one entered when registering a managed server.
Enter a character string beginning with an alphabetical character and containing up to 15 alphanumeric characters and hyphens ("-"). The following physical server names are ignored.
Blade Servers
PRIMEQUEST Servers
SPARC Enterprise Servers
Fujitsu M10 Servers
Unregistered Server
Information
When there are no definition files when registering a server, or when the physical server name to register is not described, the server is regarded as being a Fujitsu server.
Example
An example definition file is indicated below.
ServerControl,V1.0 |
