This chapter explains the necessary items for each command that belongs to the following command categories. These commands are explained in the order indicated below.
Environment definition commands
These commands are used to install Systemwalker Software Configuration Manager or create environment definitions.
Start/stop commands
These commands are used to start and stop Systemwalker Software Configuration Manager.
Operation commands
These commands are used to operate Systemwalker Software Configuration Manager.
Maintenance commands
These commands are used to collect investigation data when problems occur, and to perform various maintenance operations such as backing up and restoring data.
Note
Most commands provided by Systemwalker Software Configuration Manager cannot be executed simultaneously.
An exclusive control error will occur if a command is executed while another command is still executing.
In order to execute the commands provided by Systemwalker Software Configuration Manager, the environment variables that are set up during installation must be enabled.
For this reason, execute commands from a command prompt that is opened after Systemwalker Software Configuration Manager has been installed.
