Top
PRIMECLUSTER  Installation and Administration Guide 4.3
FUJITSU Software

J.4.4 Operator Intervention Request

Details on incompatibilities

To enable the operator intervention request, you have to set the AppWatch parameter to ON with clsetparam. With the default settings made when the cluster was installed, the operator intervention request, is disabled. For details, see "5.2 Setting Up Fault Resource Identification and Operator Intervention Request."

Changes

Before upgrading [PRIMECLUSTER 4.1A40]

The operator intervention request, is always enabled.

After upgrading [PRIMECLUSTER 4.3A30]

The operator intervention request, is enabled only when the AppWatch parameter is set to ON with clsetparam. The default value of AppWatch set when the cluster was installed is set to OFF, and the operator intervention request, will not work with this default value.

Note

For details, see "4.2 Operator Intervention Messages" in the "PRIMECLUSTER Messages."