Details on incompatibilities
If a failure occurs in the resource or if the resource recovers from a failure, the failure or recovery of the resource can be posted by sending the message shown below to syslogd. The default setting at installation is that notification of a resource failure or recovery is not posted with PRIMECLUSTER 4.3A30. For details, see "5.2 Setting Up Fault Resource Identification and Operator Intervention Request."
Message No | Message overview |
|---|---|
2700 | Recovering from a resource failure |
2701 | Recovering from a node failure |
6750 | Resource failure |
6751 | Node failure |
Changes
Notification of a resource failure or recovery will be posted.
A resource failure or recovery will be posted only when the AppWatch parameter is set to ON with clsetparam. The default value of AppWatch at cluster installation is OFF and notification of the resource failure or recovery will not be posted.
Note
After you have changed the AppWatch parameter with clsetparam, you have to reboot all the nodes to validate the setting.
