5.1 Initial Cluster Setup

This section describes the initial cluster setup for PRIMECLUSTER.

If the virtual machine function is used, you need to set up a virtual network first.

For details, refer to "PRIMECLUSTER Global Link Services Configuration and Administration Guide: Redundant Line Control Function".

For details on the setup methods, see the reference locations indicated in the table below.

	Contents	Manual reference location*
1	5.1.1 Setting Up CF and CIP (setting up cluster configuration information and IP addresses)	CF "2.1 CF, CIP, and CIM configuration"
2	5.1.2 Setting Up the Shutdown Facility	CF "8 Shutdown Facility"
3	5.1.3 Initial Setup of the Cluster Resource Management Facility	CF "4.3 Resource Database configuration"

* The PRIMECLUSTER manual names are abbreviated as follows:

Note

When Firewall is enabled, disable it before the initial cluster setup.

When enabling Firewall after completing the installation of the cluster, see "Appendix I Using Firewall."