Choose values for the following management board settings, given the following criteria:
This name is used to identify the PRIMEQUEST chassis on the admin server. Each chassis name must be unique within the system.
The first character must be alphabetic, and the name can contain up to 10 alphanumeric characters and hyphens ("-").
These IP addresses can be used to communicate with the admin server.
Name of the user account used to log into remote server management and gain control over the managed server.
A user account with at least administration privileges within the remote server management must be specified.
This user name must be between 8 and 16 alphanumeric characters long.
Password used to log in the remote management controller with the above user name.
This password must be between 8 and 16 alphanumeric characters long.
This community name can contain up to 32 alphanumeric characters, underscores ("_"), and hyphens ("-").
This must be the IP address of the admin server.
Note
To enable server cloning between servers in different chassis, use the same SNMP community for each chassis.
When using a PRIMEQUEST 2000 series, the following partition can be registered as a managed server.
PPAR partition with "Extended Partitioning Mode" set to "Disable"
Extended Partition configured on a PPAR partition with "Extended Partitioning Mode" set to "Enable"
Do not change the Extended Partitioning Mode after server registration.
When the Extended Partitioning Mode is changed to "Enable" after registration, "Extended Partitioning Mode" is displayed, but PPAR with "Extended Partitioning Mode" displayed cannot be used.
To change the Extended Partitioning Mode, delete the Extended Partitioning, then change the Extended Partitioning Mode and register it again.
