This describes how to upgrade the version of the Management Console.
Note
Coexistence of the Management Server or Master Management Server and the Management Console
If the Management Console exists with the Management Server or Master Management Server, it will be upgraded at the same time.
In this case, this procedure is not required.
Overwrite the install of the Management Console. The procedures are as follows: execute the following procedures according to "4.2 Upgrade Procedures".
Log on to a Windows with an Administrators group affiliated user or Domain Admins group affiliated user.
After inserting DVD-ROM of Systemwalker Desktop Keeper into PC, the installer window is displayed.
Select Management Console Installation.
If the Setup has been not been started, start "swsetup.exe" of DVD-ROM drive.
After the "Welcome to Systemwalker Desktop Keeper Management Console Setup" window is displayed, click the Next button.
The "Enter server information" window is displayed. Set the target server information, and click the Next button.
The procedures for setting the target server are as follows:
For the target server information, click the Add button after setting the following information.
Note
Confirm the settings of the connected Management Server/Master Management Server
Set the connected Management Server/Master Management Server information as the same as the settings in the Management Console. The following explains how to confirm:
Start Systemwalker Desktop Keeper > Server > Server Settings Tool from the Start/Apps menu on the connected (Master) Management Server.
Click the Management Server settings button.
Confirm the following items.
- Configuration value of IP address of server of Server settings
- Configuration value of Management Console <----> Level Control Service of Port number settings
Computer name or IP address of connected (Master) Management Server: Input the computer name or IP address of the connected Management Server/Master Management Server.
When inputting the computer name, input the content with name analyzed. If the name is not analyzed, Management Server/Master Management Server cannot be connected to Management Console.
The value set here will be displayed as an option of Connected Target Server Name in the logon window of Management Console. You can enter both IPv4 and IPv6 IP addresses.
Do not use link local addresses. Behavior is not guaranteed in this case.
Port number being used: Enter the port number for communication between Management Console and Level Control Service. The number must be the same as the setting for Management Console <----> Level Control Service in Port number settings.
After it is added, the set information will be displayed under the Add button.
When there are multiple target servers, operate as Procedure a. according to the number of servers.
Servers that are connected frequently can be moved up and down through the up arrow button and the down arrow button.
The "Complete installation preparation" window is displayed.
To start installation, click the Install button to start installation.
To confirm or modify the settings, click the Back button to reset.
The message below will be displayed. Click OK and continue with the installation process.
Upon completion, a window informing that the installation completed successfully will be displayed. Installation will continue until the window is displayed, so wait until completion.
The message below will be displayed. Click Finish.
The installation of Systemwalker Desktop Keeper management server was completed.
Upon successful completion, the confirmation window will be displayed.
To use the program, click Yes. The operating system will restart.
