Systemwalker Desktop Keeper Installation Guide

3.2.2 How to Restore the Assets

This section explains how to restore the assets of the Systemwalker Desktop Keeper Smart Device Relay Server.

1. Use SDSVService.bat (start/stop service of Smart Device Relay Server command) to stop the service of the Smart Device Relay Server.
   Execute this command on the Smart Device Relay Server.

2. Execute the following command:

   SDSVRestore.bat -dir backupDir

3. Using swss_ImportAppleCert.bat (register Apple Inc. certificate command), register again the MDM certificate that was prepared using the procedure in "2.2 Advance Preparation".

4. After restoration, use SDSVService.bat (start/stop service of Smart Device Relay Server command) to start the service of the Smart Device Relay Server.
   Execute this command on the Smart Device Relay Server.

Refer to "Command Reference" in the Systemwalker Desktop Keeper Reference Manual for details on each command.

Note

When Systemwalker Desktop Keeper coexists with Systemwalker Desktop Patrol, restore Systemwalker Desktop Patrol also.