This section describes the installation steps of Systemwalker Desktop Keeper.
When log analysis function and report output function are not used
The installation steps for the fundamental structure (without the Log Analyzer Server) of Systemwalker Desktop Keeper are as follows:
When the smart device management feature is used
When managing smart devices, you will need to build the Smart Device Relay Server in addition to the above procedure. Note that you should perform the procedure below before extracting the smart device (agent).
Build the Smart Device Relay Server after completing the build of the Management Server or Master Management Server.
When log analysis function and report output function are used
When the Log Analyzer Server is built and the functions of log analysis and report output are used, the following steps are required apart from the above steps.
In addition, the following steps can also be performed before extracting the client (CT) and the smart device (agent).
When a client (CT) is installed on Management Server/Master Management Server
The steps to install a client (CT) on a Management Server/Master Management Server are as follows:
Install Management Server/Master Management Server;
Install a client (CT).
Install the Management Server/Master Management Server first. Otherwise, it will be unable to install the Management Server/Master Management Server.
When installing a client (CT) on a Management Server/Master Management Server, the client (CT) can only be registered on the Management Server/Master Management Server of this server (refer to the following diagram).
