The following shows the procedure for changing configuration information for GS/SURE linkage mode:
Inactivate the concerned virtual interface using the "stphanet" command. For detail, see Section "7.3 stphanet Command".
Change the configuration information.
Reboot the system.
(Note: restarting the HUB monitoring function with "hanetpoll off/on" enables a change made on the monitoring interval, the number of times for monitoring, the monitoring recovery interval, the waiting time for a link up, or the waiting time for cluster switching.)
The following is a list of the information that can be changed for GS/SURE linkage mode. No information can be changed besides the information listed below. Delete the concerned definition and add it again.
Configuration definition information
Use the "hanetconfig" command to change the following information. For information, see Section "7.1 hanetconfig Command".
Host name or IP address to be attached to a virtual interface or a logical virtual interface
Host name or IP address to be attached to a physical interface
Interface names to be bundled by a virtual interface
Parameters
Use the "hanetpoll" command to change the following information. For information, see Section "7.7 hanetpoll Command".
Monitoring interval
The number of monitoring times
Recovery monitoring period
Cluster switching
Link up waiting period
Remote node information
Use the "hanetobserv" command to change the following information. For information, see Section "7.5 hanetobserv Command".
Remote node name
Virtual IP information (Virtual IP address, Remote physical IP address, Monitoring on/off, Send RIP from remote host on/off, Network information of relaying host)
