The following shows the procedure for changing configuration information for RIP mode:
Inactivate the concerned virtual interface using the "stphanet" command. For information, see Section "7.3 stphanet Command".
Stop the monitoring information (only if monitoring is enabled). For information, see Section "7.7 hanetpoll Command".
Change the configuration information.
After changing the configuration information, activate the concerned virtual interface using the "strhanet" command.
Start monitoring (only if monitoring is enabled). For information, see Section "7.7 hanetpoll Command".
The following lists the information that can be changed for RIP mode. No information can be changed besides the information listed below. Delete the concerned definition and add it again.
Configuration definition information
Use the "hanetconfig" command to change the following information. For information, see Section "7.1 hanetconfig Command".
Operation mode (Only RIP mode or Fast switching/RIP mode can be selected.)
Host name or IP address to be attached to a virtual interface or a logical virtual interface
Interface names to be bundled by a virtual interface
Data of monitored remote system and parameters
Use the "hanetpoll" command to change the following information. For information, see Section "7.7 hanetpoll Command".
Monitored remote system data (primary monitored remote system IP address and secondary monitored remote system IP address)
Monitoring interval
The number of monitoring times
The number of retries prior to stopping monitoring the router
Recovery monitoring period
Cluster switching
Link up waiting time
