The following shows the procedure for adding configuration information for RIP mode. When sharing NIC used in a virtual interface of the already defined Fast switching mode, RIP mode, and fast switching/RIP switching mode and adding the configuration information, use the same procedure:
Create a virtual interface using "hanetconfig create" command. If NICs are shared amongst several virtual interfaces, the same pair of physical interfaces should be specified to create each of the virtual interfaces with "hanetconfig create" command.
For information, see Section "7.1 hanetconfig Command".
Setup the router/HUB monitoring function using the "hanetpoll create" command (only if the router/HUB monitoring function is used). For information, see Section "7.7 hanetpoll Command".
