In GS/SURE linkage mode, the system uses duplicated paths concurrently but it cannot be expected to improve the throughput.
Be sure to set a function to monitor the other side to communicate when using GS/SURE linkage mode. See "7.5 hanetobserv Command" as to how to set.
GS/SURE linkage mode and RIP mode cannot be coexisted on a single system.
In GS/SURE mode, data communication with PRIMEPOWER, GP7000F severs, Fujitsu S series, GP-S, PRIMERGY, or PRIMEQUEST is not possible.
In GS/SURE linkage mode, the route to the virtual IP address of the destination system is recognized by using the RIP protocol. Set the RIP advertisement on the GS/SURE system (destination system). In this mode, RIPv1 is supported.
In GS/SURE linkage mode, communication with up to four hosts is possible. Communication with the fifth host or later is not possible.
