The application program prints the range specification barcode and basic module width barcode.
Range specification barcode
When the form descriptor is created, specify the maximum width of the printable barcode in the specified area. The printing start point is determined during printing so that the barcode is positioned at the center of the specified width.
Basic module width barcode
This function prints barcode in basic module width specified. The features of this case are as follows:
In case the barcode is larger than the field length, the barcode is printed within the field area. Therefore the barcode may not be printed in basic module width specified in the descriptor.
If the basic module width specified in the descriptor is changed for printer device density, the barcode may not be printed in basic module width specified in the descriptor. Because of the value less than 1 dot is omitted.
If the basic module width specified in the form descriptor is 9(1/1440 inch unit), the barcode is printed in basic module width 14(1/1440 inch unit).
If alphanumeric characters are specified for barcode printing and are output by the application program for the generated barcode field, the barcode is printed in the specified area.
The barcode is printed under the following conditions:
The vertical and horizontal size can be specified.
A check character can be added, and printing orientation and character printing can be specified.
Barcode reading test must be required with your Barcode Reader.
