Top
PRIMECLUSTER  Installation and Administration Guide4.3
Appendix J Changes in Each Version > J.2 Changes in PRIMECLUSTER 4.3A10 from 4.3A20 > J.2.2 clrccusetup command
PreviousNext

J.2.2 clrccusetup command

Details on incompatibilities

The number of characters displayed by "clrccusetup -l" has been changed.

Changes

Before upgrading [PRIMECLUSTER 4.3A10]

The number of characters displayed by "IP-address" of "clrccusetup -l" is 16 characters (including spaces).

After upgrading [PRIMECLUSTER 4.3A20]

When an IPv6 address is used for the IP address of the console information, the number of characters displayed by "IP-address" of "clrccusetup -l" is 40 characters (including spaces). When an IPv4 address is used, the number of characters is not changed.

Note

None.

PreviousNext
Copyright FUJITSU LIMITED 2012-2015