Shown below are examples of creating the GDS Configuration Worksheet.
System configuration example
For a system configuration example, set up the worksheet as shown below.
Examples of creating the GDS Configuration Worksheet are provided below.
Example 1. Managing a disk as a single disk:
In this example, single volumes Volume1 and Volume2 are created in physical disk c3t4d5.
Example 2. If a disk is not mirrored but may be changed to a mirror configuration later:
In this example, mirror group Group1, which consists only of physical disk c3t4d5, is created, and single volumes Volume1 and Volume2 are created in Group1.
Since Group1 consists of only one disk, Volume1 and Volume2 are not mirrored. If another disk is added to Group1, then Volume1 and Volume2 can be changed to a mirror configuration.
Example 3. If disk mirroring is to be executed:
In this example, mirror group Group1, which consists of physical disks c3t4d5 and c4t5d6, is created, and mirrored volumes Volume1 and Volume2 are created in Group1.
Example 4. If disk striping is to be executed:
In this example, striping group Group1, which consists of physical disks c3t4d5 and c4t5d6, is created, and striped volumes Volume1 and Volume2 are created in Group1.
Example 5. If disk concatenation is to be executed:
In this example, concatenation group Group1, which consists of physical disks c3t4d5 and c4t5d6, is connected, and volumes Volume1 and Volume2 are created in Group1.
Example 6. If disk striping and mirroring are to be executed:
In this example, mirror group Group1, which consists of striping group Group2 and striping group Group3, is created, and volumes Volume1 and Volume2 are created in Group1. Striping group Group2 consists of physical disks c3t4d5 and c4t5d6, and striping group Group3 consists of physical disks c3t4d6 and c4t5d7.
