Before setting up GDS, you must have configured the shared disks using automatic configuration. If the disk units were already configured with automatic configuration in "5.1.3.2 Automatic Configure," skip this operation.
Note
If the following procedures are taken, execute automatic configuration of disk units before setting up GDS.
Disk units are not set up for automatic configuration during the initial setup
Shared disk unit was added after the initial configuration
Disk labels are changed
After setting up the disk units according to the procedure described in "3.2.2 Setting Up Disk Units," either execute Automatic configure from the Tools menu of the CRM main window in Cluster Admin, or execute the following command in any one of the nodes in the cluster system:
# /etc/opt/FJSVcluster/bin/clautoconfig -rNote
If disk units were specified during automatic resource registration in "5.1.3.1 Initial Configuration Setup," the resources have already been created. If you want to check whether the disk units were registered as resources, you can reexecute automatic resource registration.
See
For details, see the manual page for the "clautoconfig(1M)" command or "4.4.3 Automatic resource registration" in the "PRIMECLUSTER Cluster Foundation (CF) Configuration and Administration Guide."