PRIMECLUSTER Wizard for NAS (PRIMEQUEST) 4.3 Configuration and Administration Guide

2.5.6 RemoteFileSystems resource creation

1. Select RemoteFileSystems from the NAS turnkey wizard to mount the NAS volume.

   Settings of turnkey wizard "NAS"
    1) HELP                              12) Crm:SystemState2(-)
    2) -                                 13) LocalFileSystems(-)
    3) SAVE+EXIT                         14) RemoteFileSystems(-)
    4) -                                 15) IpAddresses(-)
    5) ApplicationName=APP1              16) RawDisks(-)
    6) Machines+Basics(app1)             17) RC-VolumeManagement(-)
    7) CommandLines(-)                   18) VERITAS-VolumeManagement(-)
    8) Controllers(-)                    19) Netapp(Netapp_APP1)
    9) Crm:Application(-)                20) Eternusdx(-)
   10) Crm:BasicApplication(-)           21) Gds:Global-Disk-Services(-)
   11) Crm:SystemState3(-)               22) Gls:Global-Link-Services(-)
   Choose the setting to process: 14

2. When the RemoteFileSystems wizard is displayed, select AdditionalMountPoint.

   File systems (Rfs_APP1:not yet consistent)
   1) HELP
   2) -
   3) SAVE+EXIT
   4) REMOVE+EXIT
   5) AdditionalMountPoint
   6) (Filter=)
   7) (Timeout=180)
   Choose the setting to process: 5

3. When the following menu is displayed, select the mount point listed in /etc/fstab.pcl, or select FREECHOISE and enter the mount point.

   1) HELP
   2) RETURN
   3) FREECHOICE
   4) ALL
   5) /mountpoint1
   Choose a mount point: 5

   When the mount point is specified, a setup menu is displayed.
   Note that this menu is exclusive to AUTORECOVER.

   Attributes	Description
   AUTORECOVER	AUTORECOVER allows you to select whether or not the mount should automatically be recovered. If AUTORECOVER is enabled, the mount is automatically remounted when it is released.

   AUTORECOVER is enabled if it is displayed at "Currently set".

   Set flags for mount point: /mountpoint1  Currently set: REMOTE,AUTORECOVER (RA)
    1) HELP
    2) -
    3) SAVE+RETURN
    4) DEFAULT
    5) SYNC(Y)
    6) NOT:AUTORECOVER(A)
    7) SERVERCONTROLLED(C)
    8) MONITORONLY(M)
    9) RCFS(T)
   10) KEEPONLINE(K)
   Choose one of the flags: 

4. When settings are complete, select SAVE+RETURN.

5. You return to the RemoteFileSystems wizard. Change Timeout and ServerTimeout to 300s respectively. If you want to add any further mount points, select AdditionalMountPoint. If creation is complete, press SAVE+EXIT.

   File systems (Rfs_APP1:consistent)
    1) HELP
    2) -
    3) SAVE+EXIT
    4) REMOVE+EXIT
    5) AdditionalMountPoint
    6) MountPoints[0]=RA:/mountpoint1 
    7) (RootDirectory=)
    8) (ServerTimeout=300)
    9) (Filter=)
   10) (Timeout=300)
   Choose the setting to process: 3