Error message
Failed to send the start parameters. Code=0xXXXXXXXX |
Applicable versions and levels
Solaris versions: 5.0 or later
Linux versions: 5.2, V10.0L10 or later
Linux for Itanium versions: V12.0L10 or later
HP-UX versions: 5.1 or later
AIX versions: 5.1 or later
DS versions: V20L10
Action
Points to check
Are you able to mount the database directory of Jobscheduler?
If using cluster operation, are you connected to the active node server?
Cause
The Jobscheduler start parameter settings are saved to the start parameter file under the database directory of Jobscheduler. If using unmounted cluster operation, when unable to access the database directory of Jobscheduler due to the setup being on the standby node, you will be unable to set up the start parameters.
Action method
If using cluster operation, set up the start parameters after connecting to the active node. If the mount or symbolic link is out of alignment, remount or realign the symbolic link, and then perform the setup of the start parameters again.
