Super user
/opt/FJSVclora/sbin/hvoraenable userApplication Resource
/opt/FJSVclora/sbin/hvoraenable -a [ userApplication ]
hvoraenable restarts monitoring the Oracle instance and Oracle listener resources on the local node where resource monitoring is disrupted. It is available regardless of whether userApplication is activated or deactivated.
If the command is executed while userApplication is stopped, disabling resource monitoring with hvoradisable will be cancelled.
If the command is executed while userApplication is running, it will restart resource monitoring.
The command must be executed after the Oracle instance and Oracle listener are started manually. Be sure to check the resource state is changed from Warning to Online.
Information
The Oracle ASM instance resource is not monitored, so it is not necessary to cancel monitoring for them with the command.
For further details about Oracle ASM instance resources, refer to "2.3.2 Oracle ASM (Automatic Storage Management)".
Specify userApplication including Oracle resources that will be restarted monitoring.
Specify either of the Oracle instance or Oracle listener that will be restarted monitoring.
Specify them on the local node.
The option restarts monitoring all Oracle instance and Oracle Listener resources that belong to userApplication that is running on a local node and is specified for userApplication.
If userApplication is omitted, the option will restart monitoring all the Oracle resources on the local node.
0: Normal termination
1: Abnormal termination
2: Abnormal termination (restarting of resource monitoring with the -a option fails)
Note
Note that execution timing. Unexpected resource failure or userApplication failover might be caused.
Do not execute the command while state transition of userApplication is in progress.
Do not operate userApplications right after execution of the command. (At least a five-second interval is necessary.)
If Oracle instances or Oracle listeners have been stopped manually while stop of monitoring, start them up manually before the execution of this command.
Confirm the restart of monitoring by using one of the following ways.
Output of message "INFO: 0102: Fault Watching is enabled" in syslog.
Transition of resources onto the previous state("Online", "Offline").
Output of clorainfo -m command is "enable".
