PRIMECLUSTER Wizard for Oracle (PRIMEQUEST) 4.3 Configuration and Administration Guide

2.2.4 userApplication Creation (without Oracle Resources)

This section explains how to create userApplication and set up non-Oracle resources.

Set up Oracle resources after creating a database.

Non-Oracle resources are configured first as follows:

GDS setup

GDS is set as "switching disk" for standby operation.

Information

It is possible to prepare the disk class for Oracle system table space and other Oracle data respectively, and the MONITORONLY attribute of the disk class is set to "NO" for the Oracle system table space and "YES" for the other Oracle data.

userApplication setup

Create userApplication according to "PRIMECLUSTER Installation and Administration Guide".
Set up userApplication using the RMS Wizard. The RMS Wizard uses the format that allows you to select information in the menu.

2.2.4.1 userApplication creation

1. Execute hvw command on any one of the cluster nodes and start up RMS Wizard.

   # hvw -n <Configuration Name>

2. Select Application-Create in the "Main configuration menu" screen.

   

3. Select WIZSTANDBY in the "Application type selection menu" screen.

   

   Note

   • Do not select ORACLE (all caps) in this screen. This is the menu for the configuration generated with PRIMECLUSTER Wizard for Oracle 4.2.

   • If you use Oracle resources in combination with PRIMECLUSTER Wizard for NAS, refer to "PRIMECLUSTER Wizard for NAS Configuration and Administration Guide".

4. In the case of editing the userApplication name, specify ApplicationName in the "Settings of turnkey wizard "WIZSTANDBY"" screen.

   

5. Select Machines+Basics to set up nodes and basic setting of userApplication.

   

   Specify an operating node in "Machines[0]" and specify a standby node in "Machines[1]".

   Select "AdditionalMachines" if you add nodes.
   For details, refer to HELP or "PRIMECLUSTER Installation and Administration Guide".

   Information

   The following setup values are recommended. The other attributes not described below are optional.

   Attributes	Values
   AutoSwitchOver	HostFailure|ResourceFailure|Shutdown
   PersistentFault	1
   HaltFlag	yes

   

6. Select SAVE+EXIT after setting Machines+Basics.

7. Set up a resource required for the shared disk (ex. GDS) in the "Setting of turnkey wizard "WIZSTANDBY"" screen.

   

8. Return to the Main configuration menu by executing SAVE+EXIT. (Any settings related to Oracle should not be done here).

   

2.2.4.2 Configuration-Generate and Configuration-Activate

1. Execute Configuration-Generate and Configuration-Activate. Then the environment setup will successfully be completed.

   

2. Select QUIT and terminate RMS Wizard.