Register the middleware software information and the software setup information.
Refer to "Chapter 15 Software Information and Software IDs" and "Chapter 16 Registered Software Setup IDs" for registered software information and software setup information. Software IDs are determined at the time of command execution.
Follow the procedure below to register middleware information. Execute two commands that register the middleware information.
Execute commands after the manager has been started.
Execute the command that registers the first item of the middleware information. The command storage locations are as follows:
[Windows]
<ServerView Resource Orchestrator installation directory>\RCXCFMG\bin\cfmg_registermwsetup.bat[Linux]
/opt/FJSVcfmg/bin/cfmg_registermwsetup
Execute the command that registers the second item of the middleware information. The command storage location is shown below.
[Windows]
<Systemwalker Software Configuration Manager installation directory>\templates\swcfmg_registermwsetup.bat
[Linux]
/opt/FJSVcfmgm/templates/swcfmg_registermwsetup
Checking messages
If the command succeeds, the message below is displayed. The software ID starting with the "start" ID and ending with the "end" ID has been registered.
INFO: SPAC00003: The registration processing is completed. [start=SW00000010, end=SW00000057]
If an error message is output, check the message explanation. Refer to "Chapter 21 Software Parameter Setting Command Messages" for message details