Device configuration information is independently maintained in the performance management functionality.
To change the device configuration, update the device configuration information that is maintained by the performance management functionality according to the procedure shown below. Also perform the update if the configuration for a device used to execute performance monitoring and threshold monitoring has been changed.
If the configuration for a device used to execute performance monitoring and threshold monitoring has been changed, the configuration information before the update is used for performance monitoring and threshold monitoring. Performance information and threshold monitoring, shown in the procedure below, cannot be guaranteed prior to the configuration information update.
<Configuration information update procedure>
Record the performance monitoring settings contents (if performance monitoring is used)
<Recorded settings contents>
Range of Monitoring Volume No
Monitoring Interval Time
Minimum Monitoring Volume No (only for ETERNUS Disk storage system)
Maximum Monitoring Volume No (only for ETERNUS Disk storage system)
Stop performance monitoring (if performance monitoring is used)
Refer to "7.2.8 Instruction for Stopping Performance Management".
Change the configuration of the supported device.
Start performance monitoring based on the settings contents recorded in step 1. (if performance monitoring is used).
<Setting contents>
Range of Monitoring Volume No (when specifying Performance monitoring targets, select "Partial")
Minimum Monitoring Volume No (only for ETERNUS Disk storage system)
Maximum Monitoring Volume No (only for ETERNUS Disk storage system)
Monitoring Interval Time
Create Device Configuration File (Select "Yes")
Refer to "7.2.2 Instruction for Performance Management" and "7.2.3 Setting Monitoring Intervals".
Note
If the scope of monitoring volumes has been changed, set the scope of monitoring volumes according to the change.
