The procedure to register the server is as follows:
On the global navigation tab, click Server.
The registered servers are displayed on the Main pane.
On the Action pane, click Register under Server.
The information input screen is displayed. (select the registration options)
Enter the necessary information, and then click Next.
The information input screen is displayed. (enter the detailed server information)
Enter the necessary information, and then click Register.
Note
The Job Status pane allows you to confirm the completion of server registration processing. However, since the information in the Job Status pane is automatically deleted 24 hours after processing is completed, check deleted information in "11.1 Display Operation History". The server registration processing has completed when the displayed items of the Operation History screen is as follows:
Action: Register Server
State: Complete
Result: Success
Target: IP address for registered server
Please do not perform any operation for this server until the registration processing has been completed.
Please do not register a server which is managed by another Management Server.
To install the Storage Cruiser's agent on the Managed Server which the AdvancedCopy Manager's agent has been installed, it is necessary to register its Managed Server again after deleting it.
If the server is a dual stack device to which both IPv4 and IPv6 addresses are configured, register either of the two addresses.
For a server on which the following agent is installed, even if IPv6 address exists in the server, its registration is accepted only with IPv4 address.
Storage Cruiser's agent that does not support IPv6 address
