The procedure to set a NAS backup is as follows:
On the global navigation tab, click Storage.
The registered ETERNUS Disk storage systems are displayed on the Main pane.
On the Main pane, click the target ETERNUS Disk storage system.
On the Category pane, click NAS Management.
The items of the Category pane change into the items concerning the NAS Management.
On the Category pane, click Backup Management.
The backup information of NAS volumes is displayed on the Main pane.
On the Main pane, click the target NAS volume checkbox.
On the Action pane, click Set NAS Backup under NAS Backup.
The Setting for Backup NAS Volume page is displayed.
Item Name | Explanation |
|---|---|
Destination Volume to backup | This is the selection of a NAS backup volume for the backup destination. New: Creates a new NAS backup volume. |
Select TPP | This is the Thin Provisioning pool in which the NAS backup volume is created. When "New" is selected for Destination Volume to backup, specification is required. It is recommended to select a Thin Provisioning pool different from the Thin Provisioning pool to which the NAS volume is created. When only one Thin Provisioning pool exists, it is automatically selected. |
Select NAS Backup Volume | This is a selection of the NAS backup volume for the backup destination. When "Existing" is selected for Destination Volume to backup, specification is required. NAS backup volumes which are the same capacity as the NAS volume of the shared folder creation destination will be displayed. |
Enter the necessary information, and then click Create.
Information
When the NAS backup is set, the NAS backup volume, copy group, and the copy pair are automatically configured. Refer to [Information] of step 5 of "6.16.1 Create Shared Folder" for details.
