ETERNUS SF Express V16.1 / Storage Cruiser V16.1 / AdvancedCopy Manager V16.1 Web Console Guide

6.8.5 Change Extreme Cache Configuration of Volume

The procedure to change the current configuration of the Extreme Cache is as follows:

Point

Specify whether to use Extreme Cache of each volume.
After the volume is created, the Extreme Cache configuration (Enabled or Disabled) can be changed. The default setting is "Enabled" when the volume is created. The change of Extreme Cache configuration is required only when Extreme Cache is used for a specific volume.

1. On the global navigation tab, click Storage.
   The registered ETERNUS Disk storage systems are displayed on the Main pane.

2. On the Main pane, click the target ETERNUS Disk storage system.

3. On the Category pane, click Volume.
   The volume list is displayed on the Main pane.

4. On the Main pane, check the target volume checkbox. Two or more volumes can be selected.

5. Perform the following procedures according to the operation purpose.

   For Changing from Enable to Disable:

   1. On the Action pane, click Disable under Extreme Cache(Read).
      The information confirmation screen is displayed.

   2. Confirm the information, and then click Disable.

   For Changing from Disable to Enable:

   1. On the Action pane, click Enable under Extreme Cache(Read).
      The information confirmation screen is displayed.

   2. Confirm the information, and then click Enable.

Note

The Extreme Cache cannot be set to SDV or SDPV.