This section describes how to restore a volume or other data that has been backed up.
All of the data from a volume that has been saved with the snapshot high-speed backup can be restored using either Web Console or swstrestore command.
To check the restore status, use the swstreststat command.
Note
If restoring for a general file system, stop operations.
Restore an individual file as shown below. Note that you cannot restore an individual file from the Web Console.
Execute the swstdrvset command to assign a drive letter to a backup volume.
Either execute the COPY command on the command prompt window or copy the file using Windows Explorer from the backup volume.
When the copy is complete, execute the swstdrvunset command to remove assignment of that drive letter from the backup volume.
