A.2.5 Notes on Operations

Points to note when ServerView Resource Orchestrator/Systemwalker Software Configuration Manager and the Systemwalker Runbook Automation Management Server are used in the same server are explained below.

Notes on Setting Up/Canceling the Setup of the Systemwalker Runbook Automation Management Server

When ServerView Resource Orchestrator/Systemwalker Software Configuration Manager and the Systemwalker Runbook Automation Management Server are used in the same server, use the setup/cancel the setup of ServerView Resource Orchestrator/Systemwalker Software Configuration Manager to set up/cancel the setup of the Systemwalker Runbook Automation Management Server respectively.

Use the setup/cancel the setup of ServerView Resource Orchestrator/Systemwalker Software Configuration Manager to set up/cancel the setup of the Systemwalker Runbook Automation Management Server respectively.

Executing the setup command or the setup cancellation command for ServerView Resource Orchestrator will also execute the setup command or the setup cancellation command for the Systemwalker Runbook Automation Management Server.
Perform the procedure to setup or cancel the setup for the Systemwalker Runbook Automation Management Server as part of the procedure to setup or cancel the setup for Systemwalker Software Configuration Manager.

Notes on Setting Up ServerView Resource Orchestrator: To set up ServerView Resource Orchestrator again in a state where the Systemwalker Runbook Automation V15.1.3 Management Server has been installed, re-execute the procedure described in "ServerView Resource Orchestrator/Systemwalker Runbook Automation Settings".

Port number that is used when ServerView Resource Orchestrator is being set up

The following fixed port numbers are used when ServerView Resource Orchestrator is set up again:

Port number for the message broker	7676
Port number for the server function	23700

If it is necessary to change the port number, for example because these port numbers are already being used, create the following files again before performing the ServerView Resource Orchestrator setup.

[Windows]

%SWRBA_HOME%\etc\config\setup\silent_setup.ini

[Linux]

/opt/FJSVswrbam/etc/config/setup/silent_setup.ini

File Format

[SETUP]

MESSAGE_BROKER_PORT=7676

SERVER_PORT=23700

Explanation of the SETUP section

Item name	Key name
Port number for the message broker	MESSAGE_BROKER_PORT
Port number for the server function	SERVER_PORT