The system error codes are listed in the table below.
CODE | Explanation | Programmer Response |
---|---|---|
2 (0x02) | Specified file cannot be found. | [Win32] Verify the runtime environment information @CBR-SCR-KEYDEFFILE is specified correctly. |
4 (0x04) | The file cannot be accessed. | Verify the runtime environment. |
5 (0x05) | Access is denied. | Verify whether the file is allocated correctly. |
6 (0x06) | Invalid handle. | Verify the runtime environment. |
8 (0x08) | Command cannot be processed because the applicable storage area is insufficient. Not enough storage is available to process this command. | Do the following, then re-execute:
|
13 (0x0d) | The file is read-only. | Verify the file attribute. |
15 (0x0F) | The system cannot find the drive specified. | Verify whether the drive name is correct. |
19 (0x13) | The media is write protected. | Verify the disk. |
20 (0x14) | A disk unit is defective. | Confirm that the disk unit is not damaged. |
21 (0x15) | The drive is not ready. | Verify the drive. |
34 (0x22) | The incorrect disk is in the drive. | Verify the disk. |
53 (0x35) | The network path was not found. | Verify the specified network path name. |
59 (0x3B) | An unexpected network error occurred. | Verify whether the network environment is set up correctly. |
86 (0x56) | The specified network password is not correct. | Verify the specified network password. |
126 (0x7E) | The specified module could not be found. | Verify to see if the DLL for the called program exists in any of the following folders:
A called program DLL imports a calling program. Please verify the calling program name (*1) and existence of the called program DLL in one of the above folders. |
127 (0x7F) | The specified procedure could not be found. | Verify to see if the program name is exported in the DLL for the called program. (*1) |
206 (0xCE) | The file name is too long. | Verify the file name. |
193 (0xC1) | It is not a valid Win32 application. | [Win32] Please confirm that the DLL of the called program is a 32bit application. [Win64] Please confirm that the DLL of the called program is a 64bit application. |
1157 (0x485) | One of the library files needed to run this application cannot be found. | Verify to see if the DLL for the called program exists in any of the following folders.
|
1224 (0x4c8) | The demanded operation cannot be executed in the file in the user map section. | The file is used exclusively. Verify the following:
|
1231 (0x4CF) | The network location cannot be accessed. | Verify that the network environment is set up correctly. |
1785 (0x6F9) | The disk may be not formatted. | Verify that the disk is formatted. |
*1 :
[Win32] You can verify using the DUMPBIN command.
[Winx64] You can verify using the LINK command / DUMP option.
For details, refer to "Other Commands" in Appendix I of the "NetCOBOL User's Guide". For description and details on other error codes, refer to the Visual C++ on-line help.
*2 : Use the "/WAIT" option to synchronize the batch file program.