Resource Orchestrator is able to manage SPARC Enterprise servers by using their XSCF interface for the M3000 series and the ILOM interface for the T series as a remote management controller.
For M3000
For M3000, choose values for the following XSCF settings according to the criteria listed below.
These IP addresses can be used to communicate with the admin server.
Name of the user account used to log into XSCF and gain control over the managed server.
A user account with "platadm" privileges within XSCF must be specified.
The user name must start with an alphabet character, and can contain up to 31 alphanumeric characters, underscores ("_"), and hyphens ("-").
Password used to log into the remote management controller with the above user name.
The user password can contain up to 32 alphanumeric characters, blank spaces (" "), and any of the following characters.
"!", "@", "#", "$", "%", "^", "&", "*", "[", "]", "{", "}", "(", ")", "-", "+", "=", "~", ",", ">", "<", "/", "'", "?", ";", ":"
The destination for SNMP traps sent by XSCF should be set to the admin server's IP address.
Name of the SNMP community used to communicate with XSCF.
This community name can contain up to 32 alphanumeric characters, underscores ("_"), and hyphens ("-").
For T Series
For the T series, choose values for the following ILOM settings according to the criteria listed below.
These IP addresses can be used to communicate with the admin server.
The name of the user account used to log into ILOM and gain control over the managed server.
A user account with Admin privileges within ILOM must be specified.
The user name must start with an alphabet character, and can contain between 4 and 16 alphanumeric characters, underscores ("_"), and hyphens ("-").
Password used to log into the remote management controller with the above user name.
The user password can contain between 8 and 16 alphanumeric characters, blank spaces (" "), and any of the following characters.
"!", "@", "#", "$", "%", "^", "&", "*", "[", "]", "{", "}", "(", ")", "-", "+", "=", "~", ",", ">", "<", "/", "'", "?", ";", ":"
The destination for SNMP traps sent by ILOM should be set to the admin server's IP address.
Name of the SNMP community used to communicate with ILOM.
This community name can contain up to 32 alphanumeric characters, underscores ("_"), and hyphens ("-").
