PRIMECLUSTER Wizard for Oracle 4.2 Configuration and Administration Guide

Appendix D Procedure for Removal of the Oracle RAC Service Resource

This section describes the procedure for removal of the Oracle RAC service resource registered in PRIMECLUSTER Wizard for Oracle 4.1A30 environment. The procedure in this section removes the Oracle RAC service resource registered in PRIMECLUSTER RMS, not the Oracle RAC service itself.

The procedure is divided into two procedures as below:

1. In the case that the Oracle RAC service resource is removed, but a userApplication that includes the resource is not removed, refer to “D.1 Removal of only the Oracle RAC Service Resource” and remove the Oracle RAC service resource only.
   Before removal, confirm that the userApplication runs correctly without the Oracle RAC service resource.

2. In the case that the Oracle RAC service resource and a userApplication that includes the resource are removed, refer to “D.2 Removal of the Oracle RAC Service Resource and userApplication” and remove the both.
   Before removal, confirm that the removal does not cause any influence.

Note

The following steps should be done after completing the installation of PRIMECLUSTER Wizard for Oracle 4.2A01.