The operational environment must be prepared prior to upgrading Express, as described below.
Install of essential package.
According to the environment in which Upgrade Installation is executed, the packages required should be installed.
The environment and the package are as follows. The version number of the installed package shall be later than the described versions.
When the Upgrade Installation is executed excluding the following environments, this procedure is not needed.
For Red Hat Enterprise Linux 5 (for Intel64), 32-bit AdvancedCopy Manager is installed of the previous version:
libXrender-0.9.1-3.1.i386.rpm
For Red Hat Enterprise Linux 6 (for Intel64):
libXrender-0.9.5-1.el6.i686.rpm
Note
When libXrender is installed, other packages might be demanded. Install the package (the end of the package name is i386.rpm or i686.rpm) of 32-bit when OS is 64-bit environment.
The required packages for the installation are included in the OS installation media.
Execute the following command to stop the daemon of ETERNUS SF Manager.
# /opt/FJSVesfcm/bin/stopesf.sh
Back up the operating system.
Point
If a failure occurs during the upgrade, you cannot restore the environment to the pre-installation status (rollback). Therefore, it is recommended to back up the operating system before performing the upgrade.
If a failure occurs during the upgrade and you want to restore the environment to the pre-installation status, restore the system from the backup.
