In order to have Storage Cruiser's agent communicate with Storage Cruiser's manager on the correct LAN path, set the "Start IP address" as the IP address (IP address in the administrative LAN) to be used for data communication by the Managed Server.
For Solaris, Linux, HP-UX, VMware, or AIX environment, set the Start IP address as described in procedure below.
For Windows environment, the Start IP address is already configured in the installation of Storage Cruiser's agent, making this procedure unnecessary.
If Storage Cruiser's agent is currently running, execute the following command to stop it:
# /opt/FJSVssage/bin/pstorageagt |
Configure the Start IP address in the Storage Cruiser's agent.
# /opt/FJSVssage/bin/setagtip -i ipAddress |
Point
Depending on the IP address configuration on the Managed Server, make the following settings:
If only one IP address is set up on the Managed Server, specify that IP address.
If multiple IP addresses are set up on the Managed Server, select and specify a Start IP address from the network configuration of the Managed Server and the Management Server. Basically, you should specify an IP address that is set up in the LAN on the route side of the Management Server.
In firewall and other environments applying IP address translation (e.g. NAT), do not set up the IP address of the server itself but an IP address that can receive transmissions from the Management Server.
Note
The following notes apply when using the IPv6 address.
Only the global address is supported.
The Web Console displays the IP address in accordance with RFC5952. As such, the IP address format displayed may differ from the content specified using this command.
