The procedure to add iSCSI host is as follows:
On the global navigation tab, click Storage.
The registered ETERNUS Disk storage systems are displayed on the Main pane.
On the Main pane, click the target ETERNUS Disk storage system.
On the Category pane, click Connectivity.
On the Connectivity pane, click Host.
The number of hosts for each port type is displayed on the Main pane.
On the Action pane, click Add iSCSI Host under Hosts.
The information input screen is displayed.
On the Now Connected tab, specify iSCSI name and an iSCSI CA port that is connected to the host to be added. Enter the necessary information for the specified iSCSI. When entering iSCSI manually, select the Manual Input tab, and enter the necessary information. Click Add, and specify an object iSCSI name from the iSCSI Host list.
Specify the host information to add, and then click Next.
The information confirmation screen is displayed.
Confirm the information, and then click Add.
Note
If the iSCSI host is a dual stack device to which both IPv4 and IPv6 addresses are configured, register either of the two addresses.
Setting the IP address, iSCSI name, iSCSI alias name, and iSCSI host name of an iSCSI host the same as another iSCSI host may not be allowed. Refer to [Note] in "Connectivity Management" in the ETERNUS SF Storage Cruiser Operation Guide for details.
