The procedure to set REC path is as follows:
On the global navigation tab, click Storage.
The registered ETERNUS Disk storage systems are displayed on the Main pane.
On the Main pane, click the target ETERNUS Disk storage system.
On the Category pane, click Advanced Copy.
On the Advanced Copy pane, click REC Path.
The created REC path list is displayed on the Main pane.
On the Action pane, click Set under REC Path.
The screen to select remote partner is displayed.
Select the remote copy destination ETERNUS Disk storage system, and then click Next.
The REC path setting screen is displayed.
Select remote copy route and connection type between ETERNUS Disk storage systems, and then click Set.
Note
The settings of the line speed and the compression ratio of REC path is enabled only when the one or more REC paths have been added.
When the deletion of the existed REC path is only executed, the specified line speed and compression ratio are not set.
The copy destination device should have the same IP address version as the copy source device (both should have either IPv4 or IPv6).
