The new version allows for settings of the virtual interfaces in Virtual NIC mode. For details, see "7.1 hanetconfig Command".
Before modification
You cannot set virtual interfaces in Virtual NIC mode by the "hanetconfig" command.
After modification
You can set virtual interfaces in Virtual NIC mode by the "hanetconfig" command.
The new version allows for dynamically adding, deleting, and switching the physical interface bundled by the virtual interface in Virtual NIC mode. For details, see "7.9 hanetnic Command".
Before modification
You cannot change the configuration of virtual interfaces in Virtual NIC mode by the "hanetnic" command.
After modification
You can change the configuration of virtual interfaces in Virtual NIC mode by the "hanetnic" command.
The new version allows for displaying the statuses of virtual interfaces in Virtual NIC mode. For details, see "7.4 dsphanet Command".
Before modification
You cannot display the statuses of virtual interfaces in Virtual NIC mode by the "dsphanet" command.
After modification
You can display the statuses of virtual interfaces in Virtual NIC mode by the "dsphanet" command.
Virtual interfaces in Virtual NIC mode can be registered in the cluster resource management. Moreover, modifications are applied to check for any failures of HUB monitoring settings in NIC switching mode. For details, see "7.17 hanethvrsc Command".
Before modification
You cannot specify Virtual NIC mode by the "hanethvrsc" command.
After modification
You can specify Virtual NIC mode by the "hanethvrsc" command.
Before modification
Error messages are not output when registering virtual interfaces of NIC switching, for which HUB monitoring is not set, to the cluster.
After modification
Error messages are output when registering virtual interfaces of NIC switching, for which HUB monitoring is not set, to the cluster.
Parameters for Virtual NIC mode can be set. In addition, the screen displayed by the "hanetparam print" command is changed. For details, see "7.6 hanetparam Command".
Before modification
You cannot change parameters for Virtual NIC mode by the "hanetparam" command.
After modification
You can change parameters for Virtual NIC mode by the "hanetparam" command.
[Changes 2]
Before modification
Parameter entries are displayed in random order by the "hanetparam print" command.
# /opt/FJSVhanet/usr/sbin/hanetparam print Line monitor interval(w) :5 Line monitor message output (m) :0 Cluster failover (l) :5 Standby patrol interval(p) :15 Standby patrol message output(o) :3 Cluster failover in unnormality (c):OFF Line status message output (s) :OFF Hostname resolution by file(h) :NO |
After modification
Parameter entries are displayed for each switching mode by the "hanetparam print" command.
# /opt/FJSVhanet/usr/sbin/hanetparam print [Fast switching] Line monitor interval(w) :5 Line monitor message output (m) :0 Cluster failover (l) :5 Cluster failover in unnormality (c):OFF Line status message output (s) :OFF [NIC switching] Standby patrol interval(p) :15 Standby patrol message output(o) :3 [Virtual NIC] LinkDown detection time (q) :0 LinkUp detection time (r) :1 Link monitor starting delay (g) :5 [Common Setting] Hostname resolution by file(h) :NO Self-checking function(e) :NO |
Changes are made for the upper limit of the number of virtual IP addresses which can be set for the communication target monitoring function. For details, see "7.15 hanetobserv Command".
Before modification
Up to 64 virtual IP addresses can be set for the communication target monitoring function.
After modification
Up to 128 virtual IP addresses can be set for the communication target monitoring function.
