PRIMECLUSTER Global Link Services Configuration and AdministrationGuide 4.3Redundant Line Control Function

7.16 dspobserv Command

[Name]

dsphanet - Displaying the operation status of communication target monitoring

[Synopsis]

/opt/FJSVhanet/usr/sbin/dspobserv [-d]

[Feature description]

The dspobserv command displays the current operation status of communication target monitoring.

[Option]

You can specify the following option.

[-d]

An asterisk (*) is displayed at the end of a physical IP address of the active node that GLS recognizes as a communication target.

[Display format]

The following shows the display formats of monitoring status:

• The option is not specified:

  # /opt/FJSVhanet/usr/sbin/dspobserv
   observ status      =  ON
   interval           =   5 sec
   times              =   5 times
   idle               =  60 sec
   repair_time        =   5 sec
   fail over mode     = YES
  
       Node             VIP                 NIC             Status
  +----------------+-------------------+-------------------+------+
   host1            192.168.100.10      192.168.10.10       ACTIVE
                                        192.168.20.10       ACTIVE
                                        192.168.10.20       ACTIVE
                                        192.168.20.20       ACTIVE

• The option is specified:

  # /opt/FJSVhanet/usr/sbin/dspobserv -d
   observ status      =  ON
   interval           =   5 sec
   times              =   5 times
   idle               =  60 sec
   repair_time        =   5 sec
   fail over mode     = YES
  
       Node             VIP                 NIC             Status
  +----------------+-------------------+-------------------+------+
   host1            192.168.100.10      192.168.10.10*      ACTIVE
                                        192.168.20.10*      ACTIVE
                                        192.168.10.20       ACTIVE
                                        192.168.20.20       ACTIVE

Display		Contents
observ status	ON	The monitoring function is enabled.
	OFF	The monitoring function is disabled.
interval		In seconds the monitoring interval in the stationary status.
times		The monitoring count.
idle		Displays in seconds the wait time that elapses after monitoring starts and before the HUB links up.
repair_time		Displays the recovery monitoring interval in seconds.
fail over mode	YES	If the virtual interface is registered in the cluster resource, node switching is performed when all the transfer routes fail. (default)
	NO	If the virtual interface is registered in the cluster resource, node switching is not performed when all the transfer routes fail.
VIP		Displays the name of a virtual interface held by the monitored node.
NIC		Displays the hostname or IP address of a real interface to be monitored. When the -d option is specified, an asterisk (*) is displayed at the end of the physical IP address of the active node in a communication target.
Status	Active	Monitoring is in progress.
	FAIL	Monitoring failed (recover monitoring in progress).
	----	The monitoring function is disabled.

[Related commands]

hanetobserv

[Examples]

The following shows an example of displaying the status of communication target monitoring in GS linkage mode.

# /opt/FJSVhanet/usr/sbin/dspobserv