[Name]
dsppoll - Displaying the monitoring status
[Synopsis]
/opt/FJSVhanet/usr/sbin/dsppoll
[Feature description]
The dsppoll command displays the current monitoring status of monitoring information created using the hanetpoll command.
[Display format]
The following shows the display format used when no option is specified.
Display | Contents | ||||
|---|---|---|---|---|---|
Polling Status | ON | The monitoring function is enabled. | |||
OFF | The monitoring function is disabled. | ||||
interval (idle) | interval | In seconds the monitoring interval in the stationary status. | |||
(idle) | In seconds the wait time that elapses after monitoring starts and before the HUB links up. | ||||
times | The monitoring count. | ||||
repair_time | The recovery monitoring interval in seconds. | ||||
link detection | YES | The link detection function is enabled. | |||
NO | The link detection function is disabled. | ||||
FAILOVER Status | YES | Node switching is performed when the virtual interface is registered in the cluster resource. | |||
NO | No node switching is performed. | ||||
Status | ON | Monitoring is in progress. | |||
OFF | Monitoring is stopped. | ||||
Name | : The name of a virtual interface to be monitored. | ||||
Mode | d | NIC switching mode (logical IP address takeover function) | |||
e | NIC switching mode (physical IP address takeover function) | ||||
Primary Target/ | Monitoring status in Primary/Secondary monitor-to IP address or a host name and parenthesis. | ||||
(ON) | Monitoring is in progress. | ||||
(WAIT) | Waiting is in progress. | ||||
(FAIL) | Monitoring failed (monitoring is stopped). | ||||
(STOP) | Unused. | ||||
HUB-HUB | WAIT | HUB-to-HUB monitoring has stopped. | |||
ACTIVE | HUB-to-HUB monitoring is operating. | ||||
FAIL | HUB-to-HUB monitoring has failed. | ||||
OFF | HUB-to-HUB monitoring is unused. | ||||
[Related commands]
hanetpoll
[Notes]
If no option is specified, this command can be specified for a virtual interface in NIC switching mode (operation mode "d" or "e").
[Examples]
The following shows an example of displaying all the monitoring statuses properly defined using the hanetpoll command.
# /opt/FJSVhanet/usr/sbin/dsppoll |
