The following shows the recovery procedure from a line failure in Virtual NIC mode.
Some applications may need to be restarted after the recovery procedure on Redundant Line Control Function.
[One-system (currently active NIC) failure]
After line recovery, execute the following command. When a fail-back has been performed by the automatic fail-back function, this action is not required.
# /opt/FJSVhanet/usr/sbin/hanetnic change -n shaX -i ethX |
[Both-system (currently active and standby NICs) failure]
When either active NIC or standby NIC is recovered, communication is restarted by using a NIC on the recovered side. Therefore, special operation is not required.
