The procedure to configure ETERNUS Disk storage system is as follows:
Add a server.
Create a new RAID group.
Create new volumes.
Assign volumes to a server.
The procedure to configure ETERNUS Disk storage system is as follows:
On the global navigation tab, click [Storage].
The registered ETERNUS Disk storage systems are displayed on the Main pane.
On the Main pane, check the target ETERNUS Disk storage system checkbox.
On the Action pane, click [Storage Conf.] under [Wizard].
Click the [Next] button at the lower right.
Enter and select [Server Information] and [Host Bus Adapter Information].
Click the [Add] button at the lower right.
Enter and select the detailed information of the new RAID group.
Click the [Create] button or the [Skip] button.
Enter and select the information of the new volume.
Click the [Create] or [Skip] button.
Click the [Assign] button at the lower right.
Note
Even if this operation is interrupted, the new resources (server, volume and RAID group) added or created during this operation are not deleted.
To delete the new resources added or created during this operation, perform the following operations.
