Register software information and software setup information for middleware.
Refer to "Software Information and Software IDs" and "Registered Software Setup IDs" in the Operator's Guide - Software Parameter Settings for information on the software information and software setup information to be registered, The software ID is determined when the command is executed.
The procedure for registering middleware information is described below. Execute two commands that register middleware information.
Execute the commands while the manager is running.
Execute the first command that registers middleware information. The command is stored in the following location:
[Windows]
<ServerView Resource Orchestrator installation directory>\RCXCFMG\bin\cfmg_registermwsetup.bat
[Linux]
/opt/FJSVcfmg/bin/cfmg_registermwsetup
Execute the second command that registers middleware information. The command is stored in the following location:
[Windows]
<Systemwalker Software Configuration Manager installation directory>
\SWCFMGM\templates\swcfmg_registermwsetup.bat[Linux]
/opt/FJSVcfmgm/templates/swcfmg_registermwsetup
Check the message.
If the command is successful, the following kind of message will be displayed. The software IDs that have been registered are all of the software IDs between the ID indicated by "start" and the ID indicated by "end".
INFO: SPAC00003: The registration processing is completed. [start=SW00000010, end=SW00000057]
If an error message is output, check the explanation for the message. Refer to "Software Parameter Setting Command Messages" in the Operator's Guide - Software Parameter Settings for information on messages.