Points to note when ServerView Resource Orchestrator and the Systemwalker Runbook Automation Management Server are used in the same server are explained below.
When ServerView Resource Orchestrator and the Systemwalker Runbook Automation Management Server are used in the same server, use the setup/cancel the setup of ServerView Resource Orchestrator to set up/cancel the setup of the Systemwalker Runbook Automation Management Server respectively.
Use the setup/cancel the setup of ServerView Resource Orchestrator to set up/cancel the setup of the Systemwalker Runbook Automation Management Server respectively.
To set up ServerView Resource Orchestrator again in a state where the Systemwalker Runbook Automation V15.1.2 Management Server has been installed, re-execute the procedure described in "ServerView Resource Orchestrator/Systemwalker Runbook Automation Settings".
The following fixed port numbers are used when ServerView Resource Orchestrator is set up again:
Port number for the message broker | 7676 |
Port number for the server function | 23700 |
If it is necessary to change the port number, for example because these port numbers are already being used, create the following files again before performing the ServerView Resource Orchestrator setup.
[Windows]
%SWRBA_HOME%\etc\config\setup\silent_setup.ini |
[Linux]
/opt/FJSVswrbam/etc/config/setup/silent_setup.ini |
[SETUP] MESSAGE_BROKER_PORT=7676 SERVER_PORT=23700 |
Item name | Key name |
|---|---|
Port number for the message broker | MESSAGE_BROKER_PORT |
Port number for the server function | SERVER_PORT |
