When the Alert E-mail Address had been set as a monitoring condition, if a tamper is detected, an E-mail is sent to the address. The following is an example of an E-mail notice.
This is Tamper Monitor URL registered as the monitoring conditions.
If check for monitoring conditions was executed separately, a serial number is indicated.
Tamper checking is basically performed with a monitoring condition as a unit. However, if the number of contents included in the monitoring conditions exceeds a given level, the given level becomes a unit. The serial number is displayed. The phase is not displayed if the number of contents included in the monitoring conditions do not reach the given level.
This is the date and time when tamper checking started.
This is the date and time when tamper checking ended.
This is Tamper Monitor directory registered as a monitoring condition
Note
If Tamper Monitor directory is not found at Tamper checking, message is displayed after End date and the below items are not displayed.
"Tamper Monitor directory is not found."
The number of contents that might have been tampered.
This is the code that indicates the type of tamper. The meaning of the code is provided after the file list.
