This section explains how to change LAN switch basic settings.
The following settings can be changed.
LAN switch name (node name for management purposes)
Admin LAN (IP address)
User ID (LAN switch blade only)
Password (LAN switch blade only)
Privileged password (LAN switch blade only)
Connection method (LAN switch blade only)
SNMP community name
Complete the changes to the settings on the target LAN switch before performing this procedure.
Use the following procedure to change LAN switch settings:
In the ROR console server resource tree or network resource device tree, right-click the target LAN switch name and select [Modify]-[Registration Settings] from the popup menu.
The [Modify LAN Switch] dialog is displayed.
Make changes to the values as needed.
Click <OK>.
The settings for the LAN switch are changed with the entered information.
Note
It is possible to set the IP address of the target switch to another unregistered LAN switch. However, this will result in the Resource Orchestrator configuration being inconsistent with the actual network configuration.
If the IP address of the target switch is set to the same address as that of another unregistered LAN switch unintentionally, change back the target LAN switch IP address to its original value according to the instructions given in this section.
If there are more than one LAN switch with inconsistent IP address configurations, delete all registered LAN switches according to "11.4.2 Deleting LAN Switches " first, then perform Discover and Register according to "7.4.2 Registering LAN Switches".
SSH connection (SSH version 2) can be selected for the following LAN switch blades.
LAN switch blade PY CB Eth Switch/IBP 10Gb 18/8 (1.00 or later version)
LAN switch blade PY CB Eth Switch/IBP 1Gb 36/8+2 (4.16 or later version)
LAN switch blade PY CB Eth Switch/IBP 1Gb 36/12 (3.12 or later version)
LAN switch blade PY CB Eth Switch/IBP 1Gb 18/6 (3.12 or later version)
