Systemwalker Service Quality Coordinator Installation Guide

4.3 Redundant Manager Operation Model Used in Pull Operation

This section explains how to install the redundant Manager operation model for Pull operation.

Execution environment

This function is provided by Systemwalker Service Quality Coordinator Enterprise Edition. To use this function, the Manager must be Enterprise Edition, but the Agents can be either Standard Edition or Enterprise Edition.

Procedure

The procedure is as follows:

Point

To use redundant Manager operation, an Operation Management Client must be connected to each Manager.

• 4.3.1 Tasks to perform on the first Manager

  1. Install the first Manager.

  2. Define Pull communications for the first Manager.

  3. Set up the first Manager.

  4. Start the service or daemon of the first Manager and confirm that it operates normally.

• 4.3.2 Tasks to perform on the second Manager

  1. Install the second Manager.

  2. Define Pull communications for the second Manager.

  3. Set up the Manager for redundant Manager operation.

  4. Set up the second Manager.

  5. Start the service or daemon of the second Manager and confirm that it operates normally.

• 4.3.3 Tasks to perform on the Proxy Manager

  1. Install a Proxy Manager

  2. Switch the Proxy Manager from Push to Pull.

  3. Define Pull communications for the Proxy Manager.

  4. Set up the Proxy Manager for redundant Manager operation.

  5. Set up the Proxy Manager

  6. Start the Proxy Manager service or daemon and confirm that it operates normally.

• 4.3.4 Tasks to perform on the Agent

  1. Install an Agent.

  2. Switch the Agent from Push to Pull.

  3. Define Pull communications for the Agent.

  4. Set up the Agent for redundant Manager operation.

  5. Set up the Agent.

  6. Start the Agent service or daemon and confirm that it operates normally.

• 4.3.5 Tasks to perform on the first Operation Management Client

  1. Install the first Operation Management Client.

  2. Set up the communication environment of the first Operation Management Client.

  3. Start the first Operation Management Client and confirm that it operates normally.

• 4.3.6 Tasks to perform on the second Operation Management Client

  1. Install the second Operation Management Client.

  2. Set up the communication environment of the second Operation Management Client.

  3. Start the second Operation Management Client and confirm that it operates normally.