Systemwalker Service Quality Coordinator Installation Guide

4.1 Basic Manager-Agent Model Used in Pull Operation

This section explains how to construct the environment for a basic model made up of a Manager and Agents communicating in Pull mode.

Procedure

The procedure is as follows:

• 4.1.1 Tasks to perform on the Manager

  1. Install a Manager.

  2. Make Pull communication definitions for the Manager.

  3. Set up the Manager.

  4. Start the Manager service or daemon and confirm that it operates normally.

• 4.1.2 Tasks to perform on the Agent

  1. Install an Agent.

  2. Switch the Agent from Push to Pull.

  3. Set up Pull communications for the Agent.

  4. Set up the Agent.

  5. Start the Agent service or daemon and confirm that it operates normally.

• 4.1.3 Tasks to perform on the Operation Management Client

  1. Install an Operation Management Client.

  2. Set up the communication environment of the Operation Management Client

  3. Start the Operation Management Client and confirm that it operates normally.