The procedure to set remote Advanced Copy by wizard is as follows:
On the global navigation tab, click [Storage].
The registered ETERNUS Disk storage systems are displayed on the Main pane.
On the Main pane, click the target ETERNUS Disk storage system.
On the Category pane, click [Advanced Copy].
On the Advanced Copy pane, click [REC Path] or [REC Buffer].
The created REC path list or REC transfer buffer list is displayed on the Main pane.
On the Action pane, click [Remote Copy Conf.] under the [Wizard].
Remote Advanced Copy setting wizard screen is displayed, and click the [Next] button.
The screen to select the remote partner is displayed.
Select an ETERNUS Disk storage system which is the copy destination of Remote Advanced Copy, and click the [Next] button.
The screen to setup the copy table size is displayed.
Set the copy parameters to both source and destination ETERNUS Disk storage systems, and click the [Next] button.
The screen to set REC path is displayed.
Select remote copy route and connection type between ETERNUS Disk storage systems, and click the [Next] button.
The screen to select REC transfer buffer is displayed.
When using in the Asynchronous Consistency mode, select both local and remote REC transfer buffer, and click the [Next] button.
The confirmation screen of settings is displayed. Click the [Finish] button when the information is correct.
Note
The settings of the line speed and the compression ratio of REC path is enabled only when the one or more REC paths have been added.
When the deletion of the existed REC path is only executed, the specified line speed and compression ratio are not set.
The REC transfer buffer will be set to both of REC copy source and destination ETERNUS Disk storage systems when using ETERNUS SF. Therefore, free space more than specified as Size is required on both of them.
As for maximum REC transfer buffer capacity of each ETERNUS Disk storage system, please refer to the hardware manual.
