The procedure of server registration/re-loading of the Hyper-V host is as follows:
On the global navigation tab, click [Storage].
The registered ETERNUS Disk storage systems are displayed on the Main pane.
On the Main pane, click the target ETERNUS Disk storage system.
On the Category pane, click [Correlation].
On the Correlation pane, click [End to End View (Hyper-V)].
On the Main pane, check the target server checkbox to register as a Hyper-V host.
On the Action pane, click [Register/Reload] under the [Hyper-V Host].
The information input screen is displayed.
Enter the necessary information, and click the [Confirm] button on the lower right.
Point
To register the server as a Hyper-V host, it is required that the server has already been registered in this product.
For the server registration method, refer to "4.17.1 Register the server".
The Hyper-V configuration information is not automatically updated. If you have changed the configuration information, perform the above procedure to reload the Hyper-V host configuration information.
For a multipath configuration, the End to End list for Hyper-V displays only one path.
When the Hyper-V host information is reloaded on a multipath configuration, the using path information is displayed.
If initiator IP address is not set to the iSCSI initiator when connecting it, the correlation management of Hyper-V is not supported.
